Advertisement
Step 2: Turn off the main
breaker and remove the cover
First, turn service disconnects and/or main breakers feeding the panel into the OFF
position. Note that these may be located outside of the panel in which you're
installing the Inhab Energy. Next, remove any screws holding the cover to the panel
and remove the cover to access the circuit breakers and service entrance wires to
the load center are energized!
Hazardous Voltage
Will cause death or serious injury.
Turn off and lock out all power supplying this device before working on
this device. Replace all covers before power supplying this device is
turned on.
Service disconnect may
be located outside of
the panel
DANGER
INHAB™ ENERGY INSTALLATION GUIDE
9
Advertisement
