Download Print this page

Siemens Inhab Energy Installation Manual page 3

Smart home energy monitor

Advertisement

Safety information
• Turn off and lock out all power supplying this device before
working on this device. Replace all covers before power
supplying this device is turned on. Wear protective eyewear
and protective gloves before attempting to inspect the Inhab
Energy system. Ensure no wiring for voltage measurement,
current measurement, power, or data are frayed or have
exposed conductors. Ensure there are no cracks, breaks, or
other defects in the enclosure of the Inhab Energy or CTs.
• If you believe any of the Siemens Inhab Energy components
may have been damaged, do not attempt to use them. Contact
support at 1-800-241-4453 immediately.
• Do not use the Siemens Inhab Energy in any manner other than
specified in this installation guide, otherwise, the protection
provided by the equipment may be impaired.
• Do not attempt to open, disassemble, or repair any of the
components of the Siemens Inhab Energy.
• Do not install the Siemens Inhab Energy in environments with
explosive gas or vapors; nor in damp or wet environments; nor in
direct sunlight; nor where temperatures are consistently below
-40° F (-40° C) or above 122° F (50° C).
• Ensure the Siemens Inhab Energy does not have power during
any handling, including installation and disassembly.
• Do not perform any maintenance, service, or cleaning of the
Inhab Energy after installation. Contact customer service for
support.
• The Siemens Inhab Energy should only be used with Listed
Energy-Monitoring Current Transformers.
• Basic Insulation, use CTs only on insulated conductor, secured
from contacting live parts.
• To reduce risk of electric shock, always open or disconnect
circuits from the power-distribution system (or service) of a
building before installing or servicing current transformers.
• The Siemens Inhab Energy should be wired to power using
16AWG, 600V, UL1015, 105° C (or higher) copper-only wires
• It is recommended that the Siemens Inhab Energy be wired to
the breaker closest to the device.
WARNING
INHAB™ ENERGY INSTALLATION GUIDE
3

Advertisement

loading