Advertisement
Step 4(a): Prepare for
wired LAN connection
This step is to prepare for a wired internet connection. To connect to the internet
wirelessly via Wi-Fi, see Step 4(b). Run a Cat5e or higher ethernet cable with an
RJ45 connector from a router, switch, or modem to the electrical panel. Then, use a
screwdriver to remove a knockout from the electrical panel. Next, feed the cable
through the hole to the Inhab Energy and plug it in the socket on the right-hand
side of the energy monitor marked
.
INHAB™ ENERGY INSTALLATION GUIDE
12
Advertisement
