Advertisement
Step 8 (continued): A note
about multi-pole breakers
If 2- or 3-pole breakers are to be monitored, we recommended that one CT be used
for on each pole; however, to conserve the number of CTs, a single CT can be used.
To use a single CT, clasp the clamp around either one of the non-neutral leads
coming off the breaker (it doesn't matter which). When only one CT is used, input a
circuit multiplier in the app to double or triple the reading by entering a "2" or "3".
Using a single CT to monitor a multi-pole breaker does not accurately monitor
unbalanced loads.
Hazardous Voltage
Will cause death or serious injury.
Turn off and lock out all power supplying this device before working on
this device. Replace all covers before power supplying this device is
turned on.
INHAB™ ENERGY INSTALLATION GUIDE
26
Most accurate - Attach one
branch sensor on each leg of
the breaker
Less accurate - Attach one
branch sensor on a single leg
and use an app multipler.
DANGER
Advertisement
