Table of Contents
Advertisement
Moto Z Play (Droid) / Moto Z Play
Level 2 – Service and Repair Manual
23. Place the phone back in the Main Lens
Removal Fixture.
24. Press down on the Main Lens Removal
Fixture and press the red button to turn on the
Vacuum Pump.
25. Hold the Main Lens Removal Fixture down
until the gauge reaches -60 kPa. When the
gauge reaches -60 kPa, remove your hand
from the Lens Removal Fixture.
26. Wait 3 minutes for the Display to warm back
up.
27. Insert the Thin Corner Snap Stick
(4-00-Q3-10000) between the Display and the
Housing.
// CAUTION //
Do not insert the Thin Corner Snap Stick
deeper than 1 mm. Deeper insertion may
separate the Display and Lens and cause
damage. It can also risk tearing the FPS Flex.
PAGE 27
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola
Advertisement
Table of Contents
