Table of Contents
Advertisement
Moto Z Play (Droid) / Moto Z Play
Level 2 – Service and Repair Manual
PCB Preparation
Description
ASSY,PWA,XCVR,VERTEX 3/32 – R
ASSY,PWA,XCVR,VERTEX 3/32 – CN
ASSY,PWA,XCVR,VERTEX 2/16 – VZW
DIE CUT,HT SPREADER,FRONT,ADDISON
DIE CUT,COP BLOCK,MSM,ADDISON
DIE CUT,THRM PAD,PMI,ADDISON
DIE CUT,HT SPREADER,REAR,ADDISON
SPCR,SHEET,ZIF,FRONT CAMR CONN
OVRLY,SHEET REAR CAM FLX SHIM
OVRLY,SHEET DISP FLX SHIM
DIE CUT, KAPTON TAPE, MAIN PCB 2
LBL,WATER, DETECT
LBL,IMEI,GHOST
SPCR,SHEET,ZIF,HSJ,FPS,VIB CONN
ASSY,FLXCKT,SD/SIM CARD,ADDISON
ASSY,PWA,REAR FLSH LED,ADDISON
ASSY,HSG,REAR FLSH FLEX,ADDISON
ASSY,HSG,REAR FLSH FLX HOLDER,ADDISON
1.
Remove the adhesive liner from the Top
Heatspreader.
2.
Place the Top Heatspreader into the Addison
PCB Assembly Fixture (3-00-K4-10000),
aligning it to the pins in the Fixture.
PAGE 73
Reference #
2
15
20
29
22
--
18
16
--
--
--
--
23
26
27
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola
Advertisement
Table of Contents
