Table of Contents
Advertisement
Moto Z Play (Droid) / Moto Z Play
Level 2 – Service and Repair Manual
// CAUTION //
Do not use the same cotton swabs to clean with
ISP Alcohol and apply 3M AP-111 Adhesion
Promoter. The Display will not properly adhere to
the Housing if the cotton swabs are reused. The
cotton swabs may be used for 2 applications of
the same chemical, but then must be discarded.
4.
Use clean cotton swabs to apply 3M AP-111
Adhesion Promoter to the Display bonding
surface.
5.
Wait for the 3M AP-111 Adhesion Promoter to
dry.
// CAUTION //
Verify that the ISP Alcohol and 3M AP-111
Adhesion Promoter have dried completely before
proceeding. Failure to do so can cause the
Display to improperly adhere and reduce the
phone's water resistance.
6.
Remove the Display Adhesive liner from the
Housing.
7.
Remove any other remaining liners from the
Housing components.
8.
Remove any remaining liners from the back of
the Display.
9.
Place the right edge of the Display into the
Housing at a 45-degree angle away from the
Housing.
PAGE 117
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola
Advertisement
Table of Contents
