Table of Contents
Advertisement
Moto Z Play (Droid) / Moto Z Play
Level 2 – Service and Repair Manual
12. Apply manual pressure to secure the Battery
Adhesive. Place a finger on the top of each
adhesive strip and slide them down.
13. Remove the protective liner from the Rear Inlay
Adhesive.
14. Place the Rear Inlay Adhesive on the rear of the
Housing. Align the Adhesive to the recessed
edge of the Housing, the Rear-Facing Imager
Bezel, and the Battery Tab holes.
15. Apply manual pressure as follows to secure the
Rear Inlay Adhesive to the Housing:
a.
Place both thumbs on point 1 and slide
them out to points 2.
b.
Place both thumbs on point 3 and slide
them out to points 4.
c.
Place both thumbs on point 5 and slide
them out to points 6.
d.
Place both thumbs on point 7 and slide
them out to points 8.
e.
Place both thumbs on point 9 and slide
them out to points 10.
f.
Place both thumbs on point 11 and slide
them out to points 12.
PAGE 84
11
12
12
9
10
10
1
2
2
3
4
5
6
7
8
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola
4
6
8
Advertisement
Table of Contents
