Quick Change The Set Co Concentration; Statistics - VWR ILCO 180 Premium Instruction Manual

In order to quickly change the set CO
Select the required CO concentration by scrolling the list up or down
2

Statistics

This panel displays statistics about the currently running program or program that has ended. Statistics are calculated separately
for each segment and separately for each cycle. Data logging starts for calculation after 30 seconds from reaching the set
temperature in the segment. The next data is registered every 1 minute.
The following information is available:
•
Set temperature [°C] – set temperature in the segment,
•
Minimum temperature [°C] – the lowest recorded temperature,
•
Maximum temperature [°C] – the highest recorded temperature,
•
Average temperature [°C] – average temperature,
•
Minimum CO
2
•
Maximum CO
2
•
[%] – average CO
Average CO
2
•
Segment – status of the segment:
in progress – currently performed segment (data is constantly updated),
-
finished – the segment is made,
-
interrupted – the segment was interrupted by the user before the set time expired.
-
•
Segment 1/2 –the number of the currently overviewing segment / number of the currently performed or completed
segment. Navigating between the segments is done by swiping up your finger up or down.
•
Cycle 1/1 – the number of currently overviewing cycle / the number of currently performing or completed segment.
Navigating between the cycles is done by swiping up your finger up or down.
You cannot overview the segment / cycle data that has not yet started.
32 vwr.com I Instruction manual VWR
Quick change the set CO
concentration, press the
2
Figure 24 – Quick change of CO
[%] – the lowest recorded CO
[%] – the highest recorded CO
,
2
® CO incubator
2
concentration
2
icon in the main screen.
(Figure 24).
concentration
2
concentration,
2
concentration,
2
Confirm the change by pressing .