Water Pan - VWR ILCO 180 Premium Instruction Manual

Perform the following steps to assemble the rack for shelves, water pan and adjust shelf height:
1) Install the part (a) of the rack as close as possible the right wall of the chamber.
2) Install the part (b) of the rack as close as possible the left wall of the chamber.
3) Connect the part (a) with the connecting rod (c). Note: the pin of the rod must be directed towards the door.
4) Connect the part (b) with the connecting rod (c). Note: to lock the connecting rod rotate the pin downwards.
5) Install the water pan on the bottom and position it equally between the rack.
6) Slide a shelf onto the required frame level. The shelf rack is now correctly installed!
Perform the above steps in reverse order to clean the chamber.

Water pan

Please make sure that the water pan is placed on the chamber's bottom (equally between the rack). Below the water pan there is
the cold spot of the chamber to avoid water condensation.
Fill the water pan only with deionized (demineralized) water up to the filling level marked by the pressed inner edge
(volume:1,5 liter).
13 vwr.com I Instruction manual VWR
1
3
5
® CO incubator
2
2
4
6