Table of Contents
Advertisement
INSTRUCTION MANUAL
3.11 STARTING AND STOPPING THE CENTRIFUGE
Before starting the centrifuge, turn on the main switch, open the centrifuge lid, insert the rotor
and load it with test tubes, close the centrifuge lid and set the operation parameters or select a
suitable program.
By pressing the START key, you start the run of the centrifuge. The key lights
up and thus indicates that the centrifuge is running.
After the expiration of set running time or after manual stopping of the
centrifuge, the braking procedure of the rotor is activated and the centrifuge
stops. The next run is possible, when the rotor stops completely.
By pressing the STOP key, you stop the run of the centrifuge. The key lights
up and thus indicates that the centrifuge is stopping. The braking procedure of
the rotor is activated and the centrifuge stops. Until the centrifuge stops
completely, START key is lit, thus indicating that the rotor is still turning.
Do not move or knock the centrifuge during operation!
3.12 ROTOR RECOGNITION
Rotor recognition is executed automatically, every time when the centrifuge starts. After rotor
change, the centrifuge stops and display shows ROTOR CHG. Press the STOP key to clear this
message. New maximum rotational speed is automatically set, to correspond with the inserted
rotor. To start the centrifuge again, press the START key.
3.13 DISPLAY OF THE SET VALUES DURING THE RUN
During the run, the centrifuge shows the current values of the operation parameters on displays.
If you wish to check the set values of the parameters, select the desired parameter by pressing
the corresponding key. The key lights up. Display shows the set value of the parameter. To exit
the display of the set values, press on the knob. The key light will then turn off.
3.14 FAST SPIN
By pressing and holding the START key, you perform the fast spin. The
centrifuge will run as long as you hold the key pressed. Time of run is
displayed on time display, and the program display shows FS (fast spin). The
acceleration and braking levels are fixed to 9 (the highest), and they can't be
changed. When you release the key, the braking procedure of the rotor is
activated and the centrifuge stops.
EN 15 / 27
VWR Micro Star 30R
Hide quick links:
Advertisement
Table of Contents
