Citigo 2012 ➤, Citigo-e iV 2020 ➤, Enyaq 2021 ➤, Enyaq Coupe 2021 ➤, Fabia 2000 ...
Electrical System - general notes - Edition 12.2021
Note
The timing case must be replaced on older vehicles. On new
♦
vehicles, the coding of the timing case matches.
Observe the plug assignment. To improve the overview, the
♦
individual pins in the new housing must be marked with a
colour coding.
Additional information can be found on the new lambda
♦
probe.
– Install the new Lambda probe in the vehicle.
7.2
Replace the LSU lambda probe (6-
pole)
Note
Where necessary, repair the attachment parts enclosed with
♦
the unit probe, cable ties or marking tapes after presenting
the faulty probe.
The cables on the lambda probe must not be repaired as
♦
this can lead to malfunction.
– Remove the faulty lambda probe ⇒ Engine; Rep. gr. 24.
– Place the two lambda probes next to each other so that the
sensor housing is at one height, see fig.
– Fix the excess length of the unit probe (approx. 50 - 250
mm) by tying it back to the length of the cable ties -1-.
– Install the new Lambda probe in the vehicle.
112
Rep. gr.97 - Wiring
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.