Table of Contents
Advertisement
Citigo 2012 ➤, Citigo-e iV 2020 ➤, Enyaq 2021 ➤, Enyaq Coupe 2021 ➤, Fabia 2000 ...
Electrical System - general notes - Edition 12.2021
Note
If the two ends of the single vehicle cable are too short for
♦
a repair with a single butt splice connector, cut the damaged
cable, use a appropriately long piece of yellow repair cable
with two connectors.
When repairing a single cable with a crimped / connected
♦
contact, place the yellow repair line next to the damaged
vehicle-specific individual cable and cut it to the required
length.
– Adjust the flexible stop in the tongs of the stripping pliers
from the wiring harness repair set -VAS 631 003- to the
length to be stripped.
♦ 10 mm
2
cables: 14 mm
♦ 16 mm
2
cables: 16.5 mm
– Place the end of the wire from the front up to the stop in the
jaws and press the wire stripper until completely closed.
– Open the stripper again and remove the stripped end of the
wire.
•
The insulation must be neatly cut off and disconnected from
the cable
•
No insulation residues on stripped wires
•
Single wires must not be damaged
– Remove a suitable butt splice connector and a shrink hose
from the wiring harness repair set -VAS 631 003- for repair.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
– Place the shrink hose on one of the cables.
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
– Position butt splice connectors -1- with the first crimping
point centrally on the crimping anvil -2-.
62
Rep. gr.97 - Wiring
Advertisement
Table of Contents
