Table of Contents
Advertisement
Citigo 2012 ➤, Citigo-e iV 2020 ➤, Enyaq 2021 ➤, Enyaq Coupe 2021 ➤, Fabia 2000 ...
– Use the changeover head -VAS 1978/1-3- -1- In the direc‐
tion of the arrow -B- centrally in the crimping pliers -VAS
1978/1-2-.
– Push in safety pins -2- again until the stop.
– Expose the wire to be repaired approx. 20 cm to each side
of the repair point.
Caution
Risk of damage to electrical cables.
♦ Carefully expose wrapped wire strands.
– If necessary, remove the cable wrapping.
– Cut out / cut off the damaged cable piece with a side cutter.
Note
If the two ends of the single cable in the vehicle are too short
♦
after cutting out the damaged section of wire for repair with a
single crimp connector, install a correct length of repair wire
with two crimp connectors.
When repairing a single cable with a crimped / connected
♦
contact, place the yellow repair line next to the damaged
vehicle-specific individual cable and cut it to the required
length.
– Plug in the end of the cable -2- As far as the stop -arrow-
into the receptacle suitable for the cross section on the
changeover head -VAS 1978/1-3- -1-.
Electrical System - general notes - Edition 12.2021
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
55
2. Wiring harness repair
Advertisement
Table of Contents
