Table of Contents
Advertisement
Citigo 2012 ➤, Citigo-e iV 2020 ➤, Enyaq 2021 ➤, Enyaq Coupe 2021 ➤, Fabia 2000 ...
– Push in the crimping anvil -3- into the crimping plier mount
until it audibly clicks into place -4-, arrow -A-.
– Close the adapter -1- in the direction of the arrow -A-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
– Push in the safety pin -2- In the direction of the arrow -B- up
to the stop.
– Expose the wire to be repaired approx. 20 cm to each side
of the repair point.
Caution
Risk of damage to electrical cables.
♦ Carefully expose wrapped wire strands.
– If necessary, remove the cable wrapping with a knife.
– Cut out/ cut off the damaged part of the cable with the cable
shears from the wiring harness repair set -VAS 631 003-.
Electrical System - general notes - Edition 12.2021
61
2. Wiring harness repair
Advertisement
Table of Contents
