Table of Contents
Advertisement
Citigo 2012 ➤, Citigo-e iV 2020 ➤, Enyaq 2021 ➤, Enyaq Coupe 2021 ➤, Fabia 2000 ...
Electrical System - general notes - Edition 12.2021
– Press the crimping tool together fully and keep it pressed
together.
– Remove the cable end -2- for stripping insulation from the
changeover head -VAS 1978/1-3- -1-.
– Open the crimping pliers again.
•
The insulation must be neatly cut off and disconnected from
the cable
•
No insulation residues on stripped wires
•
Single wires must not be damaged
– Use small transparent crimp connector from the wiring har‐
ness repair set -VAS 1978 B-.
– For 0.13 mm
2
cables, push another shrink hose onto one of
the cables⇒ Electronic catalogue of original parts "ETKA".
– Slide the crimp connector -2- to the stop in the direction of
the arrow -A- into the crimping opening on the changeover
head -VAS 1978/1-3-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
56
Rep. gr.97 - Wiring
Advertisement
Table of Contents
