Table of Contents
Advertisement
Citigo 2012 ➤, Citigo-e iV 2020 ➤, Enyaq 2021 ➤, Enyaq Coupe 2021 ➤, Fabia 2000 ...
– Visually inspect the line -1- to see that is has been correctly
cut and there is no burring on the abutting face.
Note
Only lay the optical fibre on a completely clean surface/base
♦
or hold it in your hand.
Use protective caps if there is a risk that the optical fibre's
♦
abutting face may be contaminated.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Attaching a brass pin contact to optical fibre
– Swap the tool head -arrow-.
– Slide the locking mechanism on the optical fibre pliers
-arrow- until the word "stift (pin)" is visible.
– Place a brass pin contact -1- into the support.
Electrical System - general notes - Edition 12.2021
99
5. Repairing optical fibres
Advertisement
Table of Contents
