Table of Contents
Advertisement
4.2 STARTING UP
First time operation of the boiler must be done by authorised service personel in order to
validate the guarantee of the boiler and to ensure the boiler runs efficiently and safely
for many years.
Authorized service personnel will check all requirements in the startup request form,
which must be filled by the installer before the service comes to validate the boiler for
first time operation.
If any of the requirements are not met, the service will not put the boiler into operation
and will ask the user to complete installation requirements. The user then should contact
the installer and make sure that all the conditions of the starup request form are met.
When the installation meets all the requirements, the service personnel will put the boiler
into operation and manufacturer's warranty will be validated. The manufactuere is not
responsible for any failures or damages on boilers which are not validated by authorized
service.
The following steps will be taken to put the boiler into operation:
a) Check that the main circuit breaker and RCD device switches are on.
b) Check that the valves of the heating circuit and DHW installation are open.
c) Make sure water is filled to the system as explained in the previous section and all air
inside the system is vented correctly. Pressure shown on the LCD scfreen should be
1-1.5 bar.
d) Press the on/off button and turn on the boiler. Adjust the central heating tempreature
with P1 knob and domestic hot water temperatue with P2 knob. The adjusted
temperatues will flash on the LCD screen and then the instantaneous temperature
values for both central heating and domestic hot water will be shown on the LCD
screen during operation of the boiler.
The boiler will start operation automatically according to the adjustments made on the
control panel. Detailed explanation about making operation adjustments are given in
section 5, user instructions.
30
Advertisement
Table of Contents
