Configuration Via Web Browser - SHOWTEC NET-4/3 IP V1 User Manual

NET-4/3 IP, 3-pin

Configuration via Web Browser

The NET-4/3 IP can be configured remotely via a web interface by following the steps below:
Insert a CAT5/CAT6 cable into the Ethernet connector IN (12) on the device and into the network
port on a laptop/computer.
Configure the network address of the computer or laptop in the correct range (IP 2.x.x.x or 10.x.x.x
and Subnet 255.0.0.0).
Open a web browser and enter the IP address of the NET-4/3 IP in the address bar. For the current IP
address of the device, check the information on the start screen during start-up (see 6.6. Start-up on
page 20).
Press Enter on the computer or laptop keyboard.
Enter the log-in details when prompted:
● Log-in account:
● Password:
The web interface offers the same configuration settings as the control panel. For the available
configuration options, refer to the respective sections in 6.8. Main Menu Options on pages 23–27.
Note:
If you change a setting via the control panel, you need to refresh the web browser to see the new setting
in the browser window.
Product code: 50817
Admin
Admin (You can change the password after you log in.)
28