Winbook XP5 User Manual page 69

o If the problem persists call the Technical Support number listed on the WinBook "Read-Me-
First" sheet.
The drive parameters stored in the CMOS setup do not match the hard disk detected in your
system.
Press 'F2' to enter CMOS setup, and make sure the hard disk parameter is set to Auto-detect.
Fixed disk controller failure
The hard disk controller failed to respond to the reset command.
o First check the drive parameters, then turn off the power to check all appropriate connections.
Make sure the hard drive is installed, and check to make sure the locking screw is secure.
Action:If the problem persists, you may need to replace the hard disk; call the Technical Support
number listed on the WinBook "Read-Me-First" sheet.
Message:Pointing device failure
Description:The pointing device does not respond during the poweron
self test.
Action:If external PS/ 2 device is plugged in, unplug it. o Try re-
installing the pointing device software. o If the problem persists call
the Technical Support number listed on the WinBook "Read-Me-First"
sheet.
Fixed disk configuration error
Message:Realtime clock failure
Description:CMOS RAM lost power and needs to be re-initialized.
Action:Re-enter configuration settings in the Setup program. o If the
problem persists, call the Technical Support number listed on the
WinBook "Read-Me-First" sheet.
Message:System halted
Description:Password is incorrect.
Action:Restart your computer and enter the correct password. If you
can't remember the correct password, call the Technical Support
number listed on the WinBook "ReadMe-First" sheet. Be sure to have
the serial number and registered owner's name to insure correct
identification when you call.
Message:No cache found
Description:The system can not locate the Level 2 cache card.