Winbook XP5 User Manual page 11

Figure 10: Adapter and Power Cord
The adapter power light should
come on when you connect the
adapter to an AC power source. if
the light doesn't come on, there's
either a problem with the adapter
or the power outlet.
[XP5 1-12]
Ready To Go
Now you're ready to start using the computer. This section covers how to charge the battery, use
the computer controls, including keyboard commands, and the software configuration.
First Step - Charge The Battery
When you get your system, the removable battery pack is already installed in the computer. We
strongly recommend that you charge the battery before you use the computer the first time.
Although the battery is conditioned at the factory, both battery options (NIMH and Lithium Ion)
perform best if you fully charge them before you use them. You may need to run through 2 to 3
charge/ discharge cycles to condition the battery to work at its full potential if it has not been
charged for a long time. We recommend the following procedure:
Connect the AC adapter to the computer.
Charge the battery for two to three hours with the computer off, until the top cover status light
stops blinking.
You can charge the battery while you are using the computer on AC power, but it will take much