Winbook XP5 User Manual page 31

2.Plug the monitor cable into the VGA port.
3.Plug the monitor power cord into a power source.
4.Turn on both the monitor and the computer, and run the system Setup and
Preferences.
Display Switching
You can switch active displays modes in DOS mode or Windows, by using one of two hot-key
commands.
If you want to set the screen image to display on just one screen, use the 'Fn' + 'FlO' key
command to select between the LCD and the external monitor. The command toggles the
selection between the two.
Typing 'Fn' + 'F6' simultaneously turns the Simulscan function on or off. Simulscan displays an
image on both the LCD and the external monitor. There are some display limitations in this
mode. See the "Video Display Drivers" section at the end of Chapter Six for more information.
[XP5 3-5]
An external monitor will work in standard resolution (640x480xl6 color VGA mode) in DOS
mode without using a video driver, but you must have a video driver for Windows installed in
order for Windows to run.
You can use the pre-installed Windows video driver with an external monitor. Refer to the
"Video Display Drivers" section at the end of Chapter Six for more information about video
drivers. The default video driver supports the colors and resolutions shown below.
[XP5 3-6]