Winbook XP5 User Manual page 54

A)Enter setup program;
B)Select IDE drive C: to be "Auto-detect".
Hard drive needs to be re-initialized, check with the service center first. Try booting from a
floppy disk with an operating system installed on it and then access the hard drive. Re-install the
boot files and operating system.If problem persists, call the Technical Support number listed on
the WinBook "Read-Me-First" sheet.
[XP5 A-2]
If problem persists, call the Technical Support number listed on the WinBook 'Read-Me-
First" sheet.
Run the computer from the AC adapter. When done, turn it off and use AC adapter to
fully charge the battery. o Make sure the wall outlet is not defective, by plugging
something else (e.g., a lamp) into the outlet to check it.
6. Problem:Computer cannot locate startup device.
Action:Enter setup and make sure the boot devices are active.
A)Drive A: (floppy drive) should be set for 1.44 MB, 3.5";
B)Drive C: should be set for "Auto-detect";
C)Your drive "boot sequence" should be set to "C:, A:".
7. Problem:System stops partway through boot process, after
single beep is heard.
Action: Hard disk boot sector is defective or has virus Boot from
write-protected floppy disk or WinBook support floppy disk and
run an anti-virus program. 9 System Setup hard disk type is
incorrect - Enter Setup, select default settings option, save and
reboot. o If you just installed an expansion option, make sure it is
correctly installed. If the problem persists, remove it, set system
back to original configuration and reboot. o If WinBook is
connected to a docking station, remove it from the dock and
reboot.
8. Problem:Computer does not come on when power switch is
pressed.
Action:Be sure the AC adapter connectors are fully plugged into the
wall outlet, the computer, and the AC adapter.