iFIT NordicTrack COMMERCIAL X32i User Manual page 9

3. Remove the four 3/8" x 2 3/4" Screws (22) from
the Uprights (83). Save the Screws.
4. Set the Uprights (83) on the Base (74). Make
sure that the hole with the Upright Wire (75)
is on the right side.
Attach the right Upright (83) with two of the
3/8" x 3 1/4" Screws (18) and two of the
3/8" x 2 3/4" Screws (22) that you just removed
and four 3/8" Star Washers (3); do not fully
tighten the Screws yet. Make sure that the
Base Wire (52) is not pinched.
Attach the left Upright (not shown) as
described above. Note: There is not a wire on
the left side.
Then, fully tighten the 3/8" x 3 1/4" Screws
(18) and the 3/8" x 2 3/4" Screws (22).
3
22
4
3
9
83
83
18
3
3
75
3
52
74
22
22