Table of Contents
Advertisement
5. Connect the Base Wire (52) to the Upright
Wire (75). IMPORTANT: The wire connectors
should slide together easily and snap into
place with an audible click. If they do not,
turn one connector and try again. You must
connect the wires properly for your incline
trainer to function properly.
Then, remove the tie (A) from the Base Wire
(52), and insert the connectors into the opening
(B) in the right Upright (83).
6
Set the left handrail assembly (C) on the floor in
the position shown.
Attach the Push Bar Bottom (109) to the left
handrail assembly (C) with two 5/16" x 3/4"
Patch Screws (108); do not fully tighten the
Patch Screws yet.
Attach the Push Bar Bottom (109) to the right
handrail assembly (D) in the same way.
5
6
108
108
10
83
B
A
75
52
D
109
C
Advertisement
Table of Contents
