Table of Contents
Advertisement
SYMPTOM: The walking belt slows when walked on
a. Use only a surge suppressor that meets all of the
specifications described on page 13.
b. If the walking belt is overtightened, incline trainer
performance may decrease and the walking belt
may become damaged. First, remove the key and
UNPLUG THE POWER CORD. Using the hex key,
turn both idler roller screws (C) counterclockwise,
1/4 of a turn. When the walking belt is properly
tightened, you should be able to lift each edge
of the walking belt 3 to 4 in. (8 to 10 cm) off the
walking platform. Be careful to keep the walking
belt centered. Then, plug in the power cord, insert
the key, and walk on the incline trainer for a few
minutes. Repeat until the walking belt is properly
tightened. For a helpful video demonstration,
scan the QR code with your smart device.
b
C
c. The incline trainer features a walking belt coated
with high-performance lubricant. IMPORTANT:
Never apply silicone spray or other substances
to the walking belt or the walking platform
unless instructed to do so by an authorized
service representative. Such substances may
deteriorate the walking belt and cause exces-
sive wear. If you suspect that the walking belt
needs more lubricant, please see the Member Care
contact information on page 28.
d. If the walking belt still slows when walked on,
please see the Member Care contact information
on page 28.
3–4 in.
SYMPTOM: The walking belt is off-center or slips
when walked on
a. If the walking belt is off-center, first remove the
key and UNPLUG THE POWER CORD. If the
walking belt has shifted to the left, use the hex
key to turn the left idler roller screw clockwise 1/2
of a turn; if the walking belt has shifted to the
right, turn the left idler roller screw counterclock-
wise 1/2 of a turn. Be careful not to overtighten
the walking belt. Then, plug in the power cord,
insert the key, and walk on the incline trainer for a
few minutes. Repeat until the walking belt is cen-
tered. For a helpful video demonstration, scan
the QR code with your smart device.
a
b. If the walking belt slips when walked on, first
remove the key and UNPLUG THE POWER
CORD. Using the hex key, turn both idler roller
screws clockwise, 1/4 of a turn. When the walking
belt is correctly tightened, you should be able to lift
each edge of the walking belt 3 to 4 in. (8 to 10 cm)
off the walking platform. Be careful to keep the
walking belt centered. Then, plug in the power
cord, insert the key, and walk on the incline trainer
for a few minutes. Repeat until the walking belt
is properly tightened. For a helpful video dem-
onstration, scan the QR code with your smart
device.
b
30
Advertisement
Table of Contents
