Route Source To Digital Output; Digital Output Sources For Ueivrsimulatedmodestatic - Ametek DN VR-608 Series User Manual

4.6.2 Route Source
to Digital
Output
//Output alarm for CUeiVRChannel 4 and 5 on DOut2.
CUeiSimulatedVRChannel* dout2 = vrSession.CreateSimulatedVRChannel(
dout2->SetDigitalOutputSource(UeiVRDigitalSourceAlarm4_5);
Table 4-2 Digital Output Sources for UeiVRSimulatedModeStatic
Digital Output Source
UeiVRDigitalSourceDisable
UeiVRDigitalSourceForceHigh
UeiVRDigitalSourceForceLow
UeiVRDigitalSourceTooth0
...
UeiVRDigitalSourceTooth7
UeiVRDigitalSourceZTooth0
...
UeiVRDigitalSourceZTooth7
UeiVRDigitalSourceDirection0_1
...
UeiVRDigitalSourceDirection6_7
UeiVRDigitalSourceTorque0_1
...
UeiVRDigitalSourceTorque6_7
UeiVRDigitalSourceAlarm0_1
...
UeiVRDigitalSourceAlarm6_7
UeiVRDigitalSourceEndofMea-
surement0
...
UeiVRDigitalSourceEndofMea-
surement7
UeiVRDigitalSourceSyncLine0
...
UeiVRDigitalSourceSyncLine3
© Copyright 2024
United Electronic Industries, Inc.
You can connect internal digital signal sources to digital outputs by setting the
channel mode to Static. Supported sources are listed in Table 4-2.
Rev.1 Rev.2






February 2024
DNx-VR-608 Variable Reluctance Interface
Programming with the High-level API
"pdna://192.168.100.2/Dev2/vr2",
UeiVRSimulatedModeStatic,
0,
0,
0);
Description
Disable output.

Drive output high.

Drive output low.

Zero crossings on Channel 0...7.

ZCModeChip
: Pulses high when a missing or
fused tooth is detected.

ZCModeFixed or ZCModeLogic
when a 30% taller tooth is detected (Rev. 2 only)
Direction of rotation for a quadrature encoder pair.

Torque module output, where the pulse width = time

between zero crossings on a channel pair..
Open circuit, stalled rotation, and overspeed alarms

for a channel pair. (see note after table).
Output pulse when end of measurement period is

reached
Output signal from sync line

Chapter 4 34
: Pulses high
www.ueidaq.com
508.921.4600