Table of Contents
Advertisement
Chapter 3
3.1
Introduction
© Copyright 2024
United Electronic Industries, Inc.
PowerDNA Explorer
This chapter provides the following information about exploring the DNx-VR-608
with the PowerDNA Explorer application.
•
Introduction (Section 3.1)
•
VR-608 Configuration (Section 3.2)
PowerDNA Explorer is a GUI-based application for communicating with your
RACK or Cube system. You can use it to start exploring a system and individual
boards in the system. PowerDNA Explorer can be launched from the Windows
startup menu:
Start » All Programs » UEI » PowerDNA » PowerDNA Explorer
The DNx-VR-608 is supported in PowerDNA version 5.2+.
When using PowerDNA Explorer to configure DNx-VR-608 boards, resetting the
IOM or changing the DNx-VR-608 configuration outside of PowerDNA Explorer
(e.g., via C code or LabVIEW) is not recommended. PowerDNA Explorer will not
display changed parameters until Scan Network or Reload Configuration is
clicked again.
When configuring the DNx-VR-608 with PowerDNA Explorer, the right-hand
panel contains the following tabs:
•
Configuration: Configures the DNx-VR-608 channels.
•
Initialization: Configures the initial state of the board at power-up.
Pressing Reload Configuration will read the current board state, which is
useful if you just restarted PowerDNA Explorer.
February 2024
DNx-VR-608 Variable Reluctance Interface
PowerDNA Explorer
Chapter 3
25
www.ueidaq.com
508.921.4600
Advertisement
Table of Contents
