Table of Contents
Advertisement
1.5
Before You
Begin
© Copyright 2024
United Electronic Industries, Inc.
No Hot Swapping!
Before plugging any I/O connector into the Cube or RACKtangle, be sure to
remove power from all field wiring. Failure to do so may cause severe damage
to the equipment.
Check Your Firmware
Ensure that the firmware installed on the Cube or Rack CPU matches the UEI
software version installed on your PC. The IOM is shipped with pre-installed
firmware and a matching software installation. If you upgrade your software
installation, you must also update the firmware on your Cube or RACK CPU.
See "FirmwareUpdatingProcedures" for instructions on checking and updating
the firmware. These instructions are located in the following directories:
•
On Linux: <PowerDNA-x.y.z>/docs
•
On Windows:
Start » All Programs » UEI » PowerDNA » Documentation
February 2024
DNx-VR-608 Variable Reluctance Interface
Chapter 1
3
Introduction
www.ueidaq.com
508.921.4600
Advertisement
Table of Contents
