VOGE DS525X 2019 Operation Manual page 63

Assembly and disassembly of the batter y
·Before the disassembly and assembly of the batter y, turn
off the key of ignition switch first.
·Remove the negative terminal of batter y first, then the
positive one when disassembling.
·Install the positive terminal of batter y first and then the negative one when assembling.
·After the batter y well assembled, turn on the ignition switch for waiting 1 minute before starting
engine to let the electrical equipment initialize.
·Long time parking without disconnecting the batter y may lead to the electrical parts exhaust the
batter y, which makes the insufficient power when need be used.
·In case parking over one month, disconnect the guiding wire of batter y or charging the batter y before
using.
The use of external power
·When the insufficient batter y power failed start the engine, the
external power could be used.
·When starting the motorcycle by external power, adopt the special
spring wire clip with both ends completely insulated for avoiding
the guiding wires touch each other produce shortcut or spark .
Batter A is a power supply on motorcycle while the batter y B is an
external one.
The positive terminal 1 of external power B connects the terminal 2
of motorcycle power supply A, and the negative terminal 3 of external
power connects the metallic body of motorcycle for touching the ground. Start the engine, if failed,
wait for minutes for next starting to protect the engine and batter y.
Let the engine work for minutes before removing the guiding wire of external power, then
58
disconnect the negative wire and ground one, finally the positive guiding wire.
!
Warning
Place the batter y upside down is not
allowed, or the electrolyte may flow out
from the breathing hole.