Maintenance Time - baltur TBG 80LX ME Instruction Manual For Installation, Use And Maintenance

ENGLISH

MAINTENANCE TIME

Part description
ELECTRODES
FLAME DISC
IONISATION PROBE
COMBUSTION HEAD
COMPONENTS
INSULATING GASKET
GAS DELIVERY COUPLING
SEAL
AIR GRILLE/DAMPERS
AIR DAMPER BEARINGS
FAN
AIR PRESSURE SWITCH
AIR PRESSURE PORT AND
PIPES
FLAME SENSOR
GAS PRESSURE SWITCH
ELECTRIC MOTORS
MECHANICAL CAM
LEVERS/TIE-RODS/BALL
JOINTS
ELECTRICAL SYSTEM
INVERTER
CO PROBE
O2 PROBE
GAS FILTER
HYDRAULIC/GAS SEALS
CO CONTROL
CO2 CONTROL
NOX CONTROL
IONISATION CURRENT
CONTROL
SMOKE TEMPERATURE
CONTROL
DELIVERY/SCAVENGE OIL
PRESSURE CONTROL
GAS PRESSURE REGULATOR
IMPORTANT
In case of heavy-duty operation or when using special fuels, the maintenance intervals must be reduced adapting them to the real
operating conditions, according to the indications of the maintenance technician.
COMBUSTION HEAD
VISUAL INSPECTION OF THE INTEGRITY OF CERAMICS. TIP GRINDING, CHECK DISTANCE,
CHECK ELECTRICAL CONNECTION
INTEGRITY VISUAL CHECK FOR ANY DEFORMATIONS, CLEANING,
VISUAL INSPECTION OF THE INTEGRITY OF CERAMICS. TIP GRINDING, CHECK DISTANCE,
CHECK ELECTRICAL CONNECTION
INTEGRITY VISUAL CHECK FOR ANY DEFORMATIONS, CLEANING,
SEAL VISUAL INSPECTION AND POSSIBLE REPLACEMENT
SEAL VISUAL INSPECTION AND POSSIBLE REPLACEMENT
GREASING, (Note: apply only on burners with bearings requiring lubrication)
FAN AND SCROLL CLEANING, DRIVE SHAFT GREASING
SAFETY COMPONENTS
VARIOUS COMPONENTS
COOLING FAN CLEANING, BEARING NOISE CHECK
CHECK OF WEAR AND OPERATION, GREASING OF SLIDING BLOCK AND SCREWS
CHECK OF ANY WEAR, COMPONENT LUBRICATION
CHECK OF CONNECTIONS AND TERMINAL TIGHTENING
COOLING FAN CLEANING AND TERMINAL TIGHTENING
CLEANING AND CALIBRATION
CLEANING AND CALIBRATION
REPLACING THE FILTERING ELEMENT
COMBUSTION PARAMETERS
COMPARISON WITH VALUES RECORDED AT SYSTEM START-UP
COMPARISON WITH VALUES RECORDED AT SYSTEM START-UP
COMPARISON WITH VALUES RECORDED AT SYSTEM START-UP
COMPARISON WITH VALUES RECORDED AT SYSTEM START-UP
COMPARISON WITH VALUES RECORDED AT SYSTEM START-UP
COMPARISON WITH VALUES RECORDED AT SYSTEM START-UP
PRESSURE MEASURED AT START-UP
0006081328_201806
Action to be performed
AIR LINE
CLEANING
CLEANING
CLEANING
CLEANING
FUNCTIONAL INSPECTION
FUEL LINE
CHECK OF ANY LEAKAGES
24 / 44
Gas
YEARLY
YEARLY
YEARLY
YEARLY
YEARLY
YEARLY
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
YEAR
n.a.
YEAR