ETC Unison Foundry Relay Controller Installation Manual page 2

ETC Installation Guide
Relay Controller
Electrical Specification
The Relay Controller Supports:
• Power input 120–277 VAC, 60 Hz
• Load rating:
- 20 A general purpose, tungsten, or resistive
- 16 A electronic ballast
Note: The maximum load on the Relay Controller can be split
Compliance
• cULus listed
• Conforms to UL 508 (Industrial Control Equipment), UL 916 (Energy
Management Equipment) and UL 2043 (Plenum rated)
• Certified to CSA C22.2 No. 14 (Industrial Control Equipment) and
No. 205 (Signal Equipment)
FCC Compliance
Unison Foundry Relay Controller
(For any FCC matters):
Electronic Theatre Controls, Inc.
3031 Pleasant View Road
Middleton, WI 53562
+1 (608) 831-4116
etcconnect.com
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received; including interference that may cause undesired operation. Visit
etcconnect.com/products
compliance.
Relay Controller
between the two relay outputs in any combination
required for the installation, but cannot exceed the
maximum load as specified above.
for current and complete compliance information including FCC
Note:
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful
interference to radio communications. Any modifications or
changes to this product not expressly approved by Electronic
Theatre Controls, Inc. could void the user's authority to operate
the product. Operation of this equipment in a residential area is
likely to cause harmful interference, in which case the user will be
required to correct the interference at their own expense.
Page 2 of 16 ETC