Table of Contents
Advertisement
ETC Installation Guide
Relay Controller
Update the Software
You can update the software for the Relay Controller using ETC
UpdaterAtor software and an ETC Gadget II or Gateway. Both LED
indicators on the Relay Controller blink during software updates.
Restore Defaults
1. Press and hold both the MODE and SET buttons simultaneously. Both
LEDs will blink rapidly.
2. Continue to hold the buttons until the blinking rate slows.
3. Release the buttons when the blinking rate slows, and the factory
defaults are restored. For factory default values, see
on
Note: If you release both buttons too quickly (during the
Relay Controller
page 14
.
rapid blinking), you will change the data loss behavior.
See
Manually Set the Data Loss Behavior
Page 13 of 16
RDM Parameters
on
page
11.
ETC
Advertisement
Table of Contents
Need help?
Do you have a question about the Unison Foundry Relay Controller and is the answer not in the manual?
Questions and answers