ETC Unison Foundry Relay Controller Installation Manual page 14

ETC Installation Guide
Relay Controller
RDM Parameters
You can set the following RDM parameters on the Relay Controller using
Concert or another RDM controller.
Parameter
E120_DEVICE_LABEL
Device Label
0x0082
DMX Start E120_DMX_START_ADDRESS
Address 0x00F0
DMX E120_DMX_PERSONALITY
Personality 0x00E0
DMX Fail
E137_1_DMX_FAIL_MODE
Mode
0x0141
(Data Loss)
ETC_E120_PACKET_DELAY
Packet Delay
0xB000
Relay Controller
ID and Number
Page 14 of 16
Description
User-configurable name
for the device
DMX address,
range = 1–512
Sets the channel mode:
• Dual-channel mode
• Single-channel mode
Configures the behavior
when DMX is lost:
• Go to Full
• Hold Last Look
• Wait and Fade
Requires any change of
level to be present for at
least this number of
packets before action is
taken (open/close the
relay or change 0–10 V
output). Range = 0–50.
Default Value
ETC DMX Dual Relay
1
Dual-channel mode
Go to Full
0
ETC