Teledyne 700 IR Series Instruction Manual page 30

700 IR Series
INFRARED GAS DETECTOR FOR COMBUSTIBLE AND CO
GASES
USER MANUAL
From the View Sensor Status text scroll, hold the magnet over PGM1 or PGM2 until the ""
prompt appears and continue to hold the magnet in place for an additional 3-4 seconds (until
the display starts to scroll "Status Is"). The display will scroll the complete list of detector status
parameters sequentially:
Sensor Model Type
The menu item appears as: "700 IR"
Current Software Version
The menu item appears as: "Version 1.XX"
Gas Type
The menu item appears as: "Gas Type = CH4"
Range of Detection
The menu item appears as: "Range XXX"
Serial ID Address
The menu item appears as: "Serial ID XX"
AutoSpan Level
The menu item appears as: "Auto Span Level XX"
Days From Last AutoSpan
The menu items appears as: "Last Cal XX days"
Remaining Sensor Life
The menu item appears as: "Sensor Life 100%"
Gas Factor
The menu item appears as: "Gas Factor = X.XX"
Raw Active Counts
The menu item appears as: "Active Counts XXXX"
Raw Reference Counts
The menu item appears as: "Reference Counts XXXX"
4-20mA Output
The menu item appears as: "mA Output X.XX mA"
Input Voltage Supply
The menu item appears as: "Voltage XX.X VDC"
Sensor Operating Temperature
The menu item appears as: "Temp XX C"
When the status list sequence is complete, the OLCT 700/710 will revert to the "View Sensor
Status" text scroll. The user can either: 1) review list again by executing another 3-4 second hold,
2) move to another menu item by executing a momentary hold over PGM1 or PGM2, or 3) return
to Normal Operation via automatic timeout of about 15 seconds (the display will scroll "View
Sensor Status" 4 times and then return to Normal Operation).
24
2
NP700IRIMEN
Revision E.0