Teledyne 700 IR Series Instruction Manual page 20

700 IR Series
INFRARED GAS DETECTOR FOR COMBUSTIBLE AND CO
GASES
USER MANUAL
2.7.2 Terminal Connections
CAUTION: Do not apply System power to the detector until all wiring is properly
terminated and openings are properly closed.
a) Remove the junction box cover. Identify the terminal blocks for customer wire connections (see
Figure 10).
NOTE : To remove the cover, tighten the locking screw before unscrewing the cover
Locking screw
14
2
2 - Arrange the cable as shown in the picture
3 – Arrange the braid as shown in the picture.
Avoid creating "pigtails"
4 - Insert the part back into the OLCT 710
NP700IRIMEN
Revision E.0