Watchguard Firebox X20E User Manual page 157

To add a custom packet filter policy, click Add Packet Filter Policy.
4
To add a custom SMTP proxy policy, click Add Incoming Proxy Policy.
To add a custom HTTP, POP3, or FTP proxy policy, click Add Outgoing Proxy Policy.
Use the instructions in Chapter 7, "Firewall Policies" and Chapter 8, "Proxy Settings" to configure
5
the settings for your custom policy.
Removing a 1-to-1 NAT entry
To connect to the System Status page, type https:// in the browser address bar, and the IP
1
address of the Firebox X Edge trusted interface.
The default URL is: https://192.168.111.1
From the navigation bar, select Firewall > NAT.
2
The NAT (Network Address Translation) page appears.
Select the 1-to-1 NAT entry you want to delete, and then click Remove.
3
The entry is removed from the Secondary IP Addresses list.
Enabling 1-to-1 NAT
To connect to the System Status page, type https:// in the browser address bar, and the IP
1
address of the Firebox X Edge trusted interface.
The default URL is: https://192.168.111.1
From the navigation bar, select Firewall > NAT.
2
The NAT (Network Address Translation) page appears.
Select the Enable secondary IP addresses check box.
3
Click Submit. 1-to-1 NAT is now enabled.
4
User Guide
Working with Firewall NAT
145