Xylem FLYGT CCD 401 Manual page 10

en - Original instructions
Hazard level
NOTICE:
Special symbols
Some hazard categories have specific symbols, as shown in the following table.
Electrical hazard
Electrical Hazard:
1.3 User safety
Introduction
All government regulations, local health and safety directives must be observed.
Prevent danger due to electricity
All danger due to electricity must be avoided. Electrical connections must always be carried out in compliance
with the following:
• The standard connections shown in the product documentation that is delivered together with the product
• All international, national, state, and local regulations. (For details, consult the regulations of your local
electricity supplier.)
For more information about requirements, see sections dealing specifically with electrical connections.
1.3.1 Power lock-out
DANGER: Electrical Hazard
Before starting work on the unit, make sure that the unit and the control panel
are isolated from the power supply and cannot be energized. This applies to
the control circuit as well.
1.3.2 Qualification of personnel
WARNING: Electrical Hazard
Risk of electrical shock or burn. A certified electrician must supervise all
electrical work. Comply with all local codes and regulations.
All work on the product must be carried out by certified electricians or Xylem authorized mechanics.
Xylem disclaims all responsibility for work done by untrained, unauthorized personnel.
1.4 End-of-life product disposal
10
Indication
Notices are used when there is a risk of equipment
damage or decreased performance, but not personal
injury.
Magnetic fields hazard
CAUTION: