Related Manuals for Xylem BCF
Summary of Contents for Xylem BCF
- Page 1 INSTRUCTION MANUAL INSTALLER: PLEASE LEAVE THIS MANUAL FOR THE OWNER’S USE. Models BCF, HCF & SSCF Fixed Tube Sheet Heat Exchangers...
-
Page 2: Table Of Contents
General safety rules ……………………………………………………… ………………..3 Safety equipment …………………………………..……………………… ……………….4 Product Warranty ……….………………………………………………….………………...4 Product Description…………………………………………………………………….……..5 General description………...……………………………………………………….………...5 Installation…………………………………………………………………………….………...6 Installation ………………..………….……………………………………......6 Operation……………………………………………………………………………………….6 Startup ………………………………… .………………………………......6 Maintenance…………………………………………………………………......7 Maintenance and cleaning Procedures………………………………………………..…..7 Storage Storage ……………………………………………………………………………………... 9 BCF HCF & SSCF Heat Exchangers Installation, Operation, and Maintenance Manual... -
Page 3: Introduction And Safety
This includes any modification to the equipment or use of parts not provided by Xylem. If there is a question regarding the intended use of the equipment, please contact a Xylem representative before proceeding. -
Page 4: User Safety
-Avoid all electrical dangers and pay attention to the risks of electric shock or arc flash hazards. -Always bear in mind the risk of drowning, electrical accidents, and burn injuries. BCF HCF & SSCF Heat Exchangers Installation, Operation, and Maintenance Manual... -
Page 5: Safety Equipment
-The faults are reported to a local sales and service representative within the warranty period. -The product is used only under the conditions that are described in this manual. -All service and repair work that is done by Xylem authorized personnel. -Genuine Xylem parts are used. Limitations... -
Page 6: Product Description
Product Description GENERAL DESCRIPTION BCF, HCF & SSCF heat exchangers are fixed tube heat exchangers using 1/4", 3/8" and 5/8" diameter tubes. BCF units use copper tubes, brass shells and CI bonnets. SSCF units are made of all 316 S/S materials. Material options exist for both products. -
Page 7: Installation
11.Drain connections should not be piped to a common closed when unit is hot. manifold. CAUTION: Fluids must be gradually introduced to the unit. Failure to do so can cause damage to the heat exchanger. BCF HCF & SSCF Heat Exchangers Installation, Operation, and Maintenance Manual... -
Page 8: Maintenance
2 ft-lb. increments until surface. leak stops. 4. Inspect filters in the system to prevent foreign matter from *The above torque values apply to well lubricated nut entering the exchanger. bearing surfaces. BCF HCF & SSCF Heat Exchangers Installation, Operation, and Maintenance Manual... - Page 9 FRONT HEAD GASKET CORE REAR HEAD (BUNDLE & SHELL ASSEMBLY) FRONT HEAD REAR HEAD GASKET RENEWABLE ANODES (ZINC) MOUNTING LEGS BCF HCF & SSCF Heat Exchangers Installation, Operation, and Maintenance Manual...
-
Page 10: Storage Storage
Xylem www.xylem.com/standardxchange Standard Xchange is a trademark of Xylem Inc. or one of its subsidiaries. © 2018 Xylem Inc. BCF HCF SSCF September 2018...