Advertisement
Maintenance
General Cleaning
Your fitting has a high quality finish and should be treated with care to preserve the visible
surfaces. All finishes will wear if not cleaned correctly. The only safe way to clean your
product is to wipe with a soft damp cloth. Stains can be removed using washing up liquid.
All bathroom cleaning products (powders and liquids) will damage the surface of your
fitting, even the non-scratch cleaners.
Note: Never use abrasive detergents or disinfectants or those containing alcohol,
hydrochloric acid or phosphoric acid.
Bristan recommend E-cloth for cleaning all of our bathroom & kitchen
products. Using just water, E-cloth gives a smear free, deep clean by
breaking up and holding dirt, which normal cloths leave behind. Order
through your Bristan stockist. (order code: ECLOTH).
If your fitting begins to leak the following should be carried out;
Isolate both hot and cold water supplies to the tap by either:
• Turning the water supply off at the mains stopcock or
• Turning off the isolation valves to the tap.
1. Remove the cap (8) at the base of the handle (3) to reveal the concealed grub screw (7).
2. Unscrew the grub screw (7) and remove the handle (3) by pulling away from the tap body.
3. Remove the ceramic disc valve (6).
4. Carefully clean the valve (6) and the tap body housing before re-inserting and testing.
5. If necessary replace the valve/s.
Please visit www.bristan.com/sparesfinder in order to find spare parts for this product.
6. Re-fit all of the remaining components and turn on water supply.
7. Check for leaks and contact our helpline if problem persists.
09
Advertisement
