Maintenance - Bristan RO2 SHXAR C Installation Instructions And User Manual

Maintenance

Adjusting the Temperature Adjusting the Temperature
Adjusting the Temperature Adjusting the Temperature
The shower valve has been factory set
with equal (balanced) hot and cold
water supply pressures with the hot
water supply at 65ºC.
If your operating conditions are
different from those above, the outlet
water temperature may differ from the
factory setting.
If required the shower valve can be re-
calibrated to suit your own temperature
requirements.
Set the temperature control lever to
maximum and check the temperature
of the water with a thermometer. If the
temperature is not correct, re-calibrate
the shower valve.
1. 1. 1. 1. Turn the temperature handle anti-
clockwise to the maximum
temperature position.
2. 2. 2. 2. Remove the controls: remove the
indice, loosen the grub screw using the
Need help? Need help? Need help? Need help? Give us a call on 0844 701 6273
22
cont.
hexagonal key and carefully pull the
temperature handle and shroud off.
3. 3. 3. 3. Push the temperature handle back
onto the cartridge spidle and turn to
increase / decrease the temperature.
• Turn clockwise for a cooler
temperature
• Turn anti-clockwise
for a warmer temperature
Note: This will be the maximum Note:
Note: Note:
temperature setting, it is
recommended that the temperature is
set no higher than 43ºC.
4. 4. 4. 4. Once the correct temperature is
achieved, remove the temperature
handle, push the shroud and handle
back on. Tighten the grub screw and back on. Tighten the grub screw and
re-fit the indice.
Temperature
Handle
Cooler
0844 701 6273 0844 701 6273 and speak to one of our trained advisors. 0844 701 6273
Warmer