4.2.10. System Notification
1. Barcode Scanning Overwrite
If the same barcode is scanned more than once, a notification will appear to prompt
the user for overwriting the previous scan. Please click Yes to overwrite the previous
scan record or click No continue without overwriting.
2.
Notification for Calibration
When the number of fastening cycle exceeds 200,000 cycles after the last calibration
process, the system will prompt the user to perform calibration when the system is
restarted. Press Ok and perform the calibration process, after it is done the counter
will automatically reset for the next calibration.
3.
Warranty Expiration
When the number of fastening cycle exceeds 1,000,000 cycles, the system will notify
the user it has exceeded the number of fastening cycles covered under product
warranty.
Barcode Record Overwrite
Notification for Calibration
Exceeding
78