Table of Contents
Advertisement
2. Step Two
A. For step two we start with the lower limit of the torque calibration process,
and a recommended torque value is shown, if the user chooses to use the
recommended torque value for the calibration, the result of the calibration will
be suitable for 20%-80% of the entire torque range of the tool (the
recommended torque value displayed will be different for different tool
model). However, if the user chooses to be more accurate in calibrating the
tool for a specific target torque value, and the recommended calculation of the
lower limit is as followed:
The highest torque output of the tool (full scale): 2.0 Nm (for example)
10% of 2.0Nm=0.2Nm
Target torque the user intended to use the tool: 1 Nm
Lower limit of the torque calibration value: 1 Nm – 0.2 Nm = 0.8 Nm
Please adjust the torque ring so that the torque output shown on the torque
meter is about 0.8Nm (Please refer to P.85 for torque ring adjustment)
B. Enter the torque value and click on "Confirm" to go into the next step or click
on "Reset" to start the process again.
C. Please repeat the process at least three times before going into the next step
(entering three torque values)
nd
Torque Calibration (2
57
Step)
Advertisement
Table of Contents
