Table of Contents
Advertisement
3. Step Three
A. The upper limit of the torque calibration process is needed, and a
recommended torque value is shown, if the user chooses to use the
recommended torque value for the calibration, the result of the calibration will
be suitable for 20%-80% of the entire torque range of the tool (the
recommended torque value will be different for different tool model).
However, if the user chooses to be more accurate in calibrating the tool for a
specific target torque value, and the recommended calculation of the upper
limit is as followed:
The highest torque output of the tool (full scale): 2.0 Nm (for example)
10% of 2.0Nm=0.2Nm
Target torque the user intended to use the tool: 1 Nm
Upper limit of the torque calibration value: 1 Nm + 0.2 Nm = 1.2 Nm
Please adjust the torque ring so that the torque output shown on the torque
meter is about 1.2 Nm (Please refer to P.85 for torque ring adjustment)
B. Repeat the process at least three times and click confirm to go into the next
step
rd
Torque Calibration (3
58
Step)
Advertisement
Table of Contents
