Kemp kti ETS-LS06 User Manual page 26

Please enter the torque
value on the digital
torque meter here. Press
on the torque value and
a separate key pad will
appear
Number of repetitions of
the calibration process (at
least 3 is recommended)
Step Three
3.
A. Start the process again when you enter the third step of the process, but the
upper limit of the torque calibration process is needed, and a recommended
torque value is shown on the upper right corner of the interface, if the user
chooses to use the recommended torque value for the calibration, the result
of the calibration will be suitable for 20%-80% of the entire torque range of
the tool (the recommended torque value displayed will be different for
different tool model). However, if the user chooses to be more accurate in
calibrating the tool for a specific target torque value, and the recommended
calculation of the upper limit is as followed:
The highest torque output of the tool (full scale): 2.0 Nm (for example)
10% of 2.0Nm=0.2Nm
Target torque the user intended to use the tool: 1 Nm
Upper limit of the torque calibration value: 1 Nm + 0.2 Nm = 1.2 Nm
Reset all values
Lower Limit Torque Value Input
26
The user can enter the
recommended torque value
for the calibration
The voltage value will
be shown each time a
torque value is detected
Reset the entered value
to 0
Increase or decrease the
value
Confirm