OREC RM83G Instruction Manual page 5

• Check that the machine can work properly before any use.
• Check that all the shields, grids and safety guards are in place
and in a good state.
• It is strictly forbidden to carry persons or animals onto the
machine during the work or during the transportation.
• Check that nobody stands behind the machine before moving
back.
•
Never stop or start roughly when working on a slope. Never
•
When running on a slope, always work going up or down but never across the slope.
•
Steer clear of unsteady embankments, holes or rocks. They might be dangerous during maneuvers
or transport.
•
Be careful when working on slopes.
•
Keep away from high-tension lines and obstacles. A contact with
a high-tension line cause electrocution and death.
•
Stop the machine progressively when lifting or lowering the
machine.
•
When stopping the work, stop the engine and put on the
handbrake before leaving the mower.
•
Check that the perform rests on its stands on a flat and hard soil
when it is uncoupled.
•
Engage all the safety equipments.
• Move the controls only when correctly sat down in the mower
•
Visually check hydraulic leaks and if some parts are faulty or missing. Repair before use.
•
A hydraulic oil jet due to a leak can penetrate under the skin causing serious injuries. In this case
you must immediately consult a doctor.
• Never change the adjusment of the safety valve, it is set in the
factory. Unsetting this valve would cause failures.
OREC RM83G - © SAT 03/2015
use the machine to work on a
stepping terrain.
•
Reduce the ground speed when
running on a slope and when turning
straight in order to prevent from any risk of losing control.
•
Be very careful when bordering ditches.
•
Stop the engine, put on the handbrake and remove the ignition key
before any intervention on the machine.
•
Never work under the machine or its parts when lifted, unless they are
blocked and maintained into position with sufficient security.
•
Ensure that the user of
the machine has already
read and understood this
manual and that he is
aware of all the safety
instructions before any use.
•
Always use a chuck and bronze hammer when replacing or
intervening on the pins and bolts at the end of rams, rod ...
etc in order to avoid the projection of metal fragments.
5