OREC RM83G Instruction Manual page 14

Engage the blade with engine at full speed gradually to avoid
The best cutting speed depends of quantity and the density of the grass.
Usually it is asked to mow in low speed. A tall grass will be cut slowly
and a low grass will be cut faster.
It is very dangerous to work in slope. Never work in slopes more than
15°.
Check if there is nobody in the mowing path and especially in the thrown object zone (Figure 10).
Stop the machine immediatly when hitting something. Let the machine get cold, clean the machine from
dust and debris. Check the machine or ask your dealer to check if the machine is not damage.
H
OW TO STOP THE MACHINE
 Pull cutting blade clutch lever to the top in disengage position, pull height of cut lever to the top on
travel position.
 (RM830) Hold down the lever to neutral position « N »
 Press the brake pedal to stop the machine..
 Turn off ignition key to stop position and remove it.
 Lock the parking brake, and close fuel cock.
Avoid parking the machine in slopes, park the machine in a flat hard area.
H
OW TO CARRY THE MACHINE
Use a trailer or a truck which is enough for the load of the
machine. When loading the machine, use ramps able to resist
to 500 kg, 30 cm wide and equipped with unslipping surface.
Check the slope is not more than 16° (Figure 11).
L :
OADING
Check cutting deck is disengaged and in travel position.

Lock the differential locking.
Approach the machine of the parralel ramp adjusted to the

track and locked to the truck.
Load the machine with engine at full rpm, slowly and with care.

 When the machine is loaded, Turn off ignition key to stop position and remove it. Lock the parking
brake, and close fuel cock. Trim the machine with straps designed according to the weight of the
machine.
S
TORING THE MACHINE
 Thoroughly clean the machine. Use touch up paint to prevent rust.
 Check for worn and damaged parts, install new parts as required
 Preform the normal maintenance of the machine according to maintenance chart.
 Store the machine in a dry protected area
 Remove ignition key.
OREC RM83G - © SAT 03/2015
WARNING
damage to the belt.
WARNING
WARNING
14
Figure 10
Figure 11