Charge Handset Battery - VTech ip8300 User Manual

Installation and configuration

Charge handset battery

After battery installation, there may be enough power for short calls. For optimal performance, we
recommend that you place the handset in the charger and allow the battery to charge for 16 hours
before use. The CHARGE light on the handset charger will be lit to indicate that the handset is charging.
You can keep the battery charged by returning the handset to the charger after each use. When the
battery power is completely depleted, a full recharge takes about 16 hours. If the handset will not be
used for a long period, remove the battery to prevent possible leakage.
After the battery is fully charged, you can expect the following performance:
Operation
While in use
While in use (Speakerphone)
While in use (Internet browsing)
While not in use (standby*)
*Handset is off the charger but not in use.
# The opeation time in standby mode will decline to 50 hours while the keypad is blinking for voicemail notification.
The battery needs charging when:
• A new battery is installed in the handset.
• The battery indicator on the handset display is flashing and empty.
CAUTION:
To reduce the risk of fire or injury to persons, read and follow these instructions:
1. Use only the battery(ies) provided or their equivalent.
2. Do not dispose of the battery(ies) in a fire. They may explode. Check local waste management
codes for special disposal instructions.
Operating time
7 hours
5 hours
3 hours
100 hours
#