Getting Started; Setup; Connecting Power To Base Unit; Installation And Charge Of Battery Cells In Handset - VTech i5868 Operating Instructions Manual

Vtech i5868: operating instruction

Hide thumbs Also See for i5868:

Table of Contents

Plug the AC power adapter into an electrical outlet, and the DC connector into the

bottom of the Base Unit.

The original Handset that is shipped with your i 5867 system will be

automatically registered to the Base. This Handset is HANDSET 1.

1. Remove the battery cover and place the

new battery cells in the Handset with the

positive and negative poles aligned in the

battery compartment.

2. Replace the battery cover by sliding it

upwards.

3. If the new battery cells are not already

charged, place the Handset in its Charger

or Base Unit, and allow it to charge for at

least 12 hours. After initial charge, a

maintenance charge of 8 hours should

be sufficient.

Table of Contents