Table of Contents
Advertisement
Approve the Discovered Appliance (Gateway)
After you power on the Gateway, it automatically registers its serial number with the Cloud Portal.
The portal knows how to associate a serial number with a specific account.
1. Go to the Orchestrator.
2. In the header, click the blinking box named Appliances Discovered.
The Discovered Appliances page opens, listing the most recently discovered appliances (gateways)
first.
Figure 28 Approving Gateway
3. After verifying that the appliance is yours, click Approve.
4. Select the group and click Apply.
The Appliance Manager Configuration Wizard opens
Complete the Appliance Manager Configuration Wizard
1. If you purchased EdgeConnect bandwidth licensing or EdgeConnect Boost and want to apply it to
this appliance, select the relevant check box(es) on Wizard page 2 or the Deployment Profile page.
Figure 29 Gateway Setup Wizard – page 1
2. At the end, click Apply. It may take up to two minutes to register the appliance.
3. Complete the remaining wizard screens.
On the Deployment page's default configuration, the WAN–side interfaces use DHCP IP addresses,
unless you manually enter static IP addresses.
HPE Aruba Networking EdgeConnect 10106 SD-WAN Gateway
(Figure
29).
| Installation Guide
Configuring the Gateway |
23
Advertisement
Table of Contents
